Q- Log Controls And Systems

Relay Boards Or Relay Modules:- Available in 4/8 relay variants and 1 changeover contact and 2 changeover contacts. Ideally suitable for switching small loads up to 10 Amps. Omron make CE/UL approved relays are used. Input signal can be PNP or NPN type. Jumper selection reduces wiring. Relay boards with fuse are also available. Contact rating 10 Amps.Boards with WAGO connectors can be supplied.

Relay Board with fuse protection :- Available in 4/8 relay variants and 1 changeover contact. Ideally suitable for switching small loads up to 10 Amps. Omron make CE/UL approved relays are used. Input signal can be PNP or NPN type.Fuse is used for short circuit or overload protection. Contact rating is 10 Amps.Boards with WAGO connectors can be supplied.

New relay boards :

1)24 VAC/DC relay board 1 CO

2)24 VAC/DC relay board 2CO

3)12 VDC relay board 1CO

4)5 VDC relay board 1CO

5) 48 VDC relay board 1 CO

6) 110 VAC relay board 1CO and 2 CO

7) 230 VAC relay board 1CO and 2 CO

Relay board 16 Ch,1CO for Mitsubishi PLC DO with D connector:
Application:This Relay Interface Module is to be used for connecting Mitsubishi 16 point DO modules with D connector to
loads like contactors/solenoid valves/indications etc.Load and PLC o/ps are galvanically isolated .
COMPONENT SPECIFICATIONS
Relay:24VDC coil,1 changeover Omron
Relay socket:1 changeover PCB soldering type
Terminals:screw type suitable for 2.5 sq. mm wires
Profile and end plates:Phoenix make
TECHNICAL SPECIFICATIONS
Input data:
Operating voltage : 24 VDC +/- 10%
Input current :Max 20mA@24 VDC
Protection across relay coil :Free wheeling diode
Indication :3mm LED
Connection : 25Pin D connector
Output Data:
Contact type :SPDT (1 changeover NO-Pole-NC)
Max. current :10Amps@250 VAC or 30 VDC
Fuse protection :available on request
Output wiring :Potential free
Terminals : screw type suitable for 2.5 sq. mm wires
Conductor size :025-2.5 sq. mm
Module dimensions (HXLXD) : 90x253x60 (WxLxH)
Order code: QLOG-25D-RLB-1CO

LOW VOLTAGE AND LOW CURRENT RELAY BOARD :- This range of relay boards are to be used for Non standard signals.These relay can operate from 1V-24VDC.The driving current is also less than 1mA. This is a 5V relay board and can be driven with less than 1mA driving current Specialy designed to use with microcontroller output ports and Texas Instruments make digital output modules.The module is available in 4/8/12/16 channels. The module requires external supply voltage as 5V/12V/24VDC.The operating power is drawn from the supply voltage.The input signals to switch the relays can be 5V,10V or 24V depending on system design.